Alarm output
The number of alarm outputs provided in the design of the registrar.
Alarm outputs are used to transmit signals from the recorder to other elements of the security system — an alarm siren, electronic locks, spotlights, etc. Thus, the system can automatically respond to events recorded by the registrar — for example, block the doors when moving in the frame.
Bandwidth
The maximum data stream in Mbit/s that the NVR is capable of processing when recording and displaying. The throughput parameter is specified as the maximum incoming/outgoing speed, or as the sum of incoming and outgoing streams (total throughput). It is calculated in such a way that the throughput exceeds the total flow of all IP cameras connected to the DVR, and another 25–30% is put in reserve for playing video or viewing it via network access.
Video compression format
Standards (codecs) used by the recorder to compress the recorded video.
This parameter is important when viewing recorded materials on another device — for example, a media centre, into which a "flash drive" with files from the recorder is inserted. For normal viewing, it is necessary that the player supports the appropriate codec — otherwise the video will be displayed with distortion or will not work at all. Technical details on various standards can be found in special sources.
Note that if you plan to view the materials on a computer, you can not pay much attention to this parameter: most modern operating systems have extensive built-in sets of codecs, and if you don’t have the right codec, you can easily find it on the Internet.
Max. resolution (IP)
The maximum supported resolution of IP cameras with which the NVR is technically capable of working (primarily recording). With rare exceptions, devices record in maximum resolution from all connected IP cameras. However, the limiting factor here is bandwidth (see the relevant paragraph) – depending on the shooting conditions, it may not be enough.
High resolution allows you to get a more detailed image in which fine details are better visible. On the other hand, such videos take up large amounts of disk space, and their support significantly affects the cost of the device.
Max. total capacity
The largest total storage capacity with which the recorder is able to work correctly. By default, it is indicated only for internal media with a SATA interface (see above), however, in some models, data is also provided separately for external devices connected via eSATA.
Note that the limit on the total capacity follows from the fact that each individual port has its own limit on the capacity of the drive. In this case, the maximum capacity is distributed equally between the ports. This should be taken into account when choosing drives for the registrar: for example, in a 32 TB model with 8 SATA connectors, the limit for each connector will be 32/8 = 4 TB. This means that installing two internal 8 TB disks in such a registrar will not work, although their total capacity will be less than the maximum.
Maximum humidity
The highest relative air humidity at which the recorder is able to operate for an unlimited time without failures and breakdowns.
High air humidity has a negative effect on electronics: moisture can settle on various parts, including current-carrying, cause corrosion, short circuits, etc. This does not happen immediately, short-term work in high humidity may not cause any trouble, but a long stay in such conditions is not recommended. However, in most modern recorders, the permissible humidity is quite high — about 90%; indoors, such conditions are very rare.
