Comparison TP-LINK Tapo C210 vs Xiaomi Mi 360 Smart Camera 2K

The largest capacity of a memory card with which a video surveillance camera can work correctly.

High-capacity drives require fairly high processing power and may use special technologies that are not supported by all cameras. This is the reason for the limitation on the volume of supported media.

Active protection methods implemented in the camera.

By itself, this function is intended to cause discomfort to the attacker and scare him away, as well as draw attention to the situation. It can be activated both manually and automatically (for example, by a motion sensor or a signal to the alarm input of the camera). There are two main types of active protection:

— Light (strobe). A bright light source that flashes at a rate of several flashes per second. Immediately after turning on, the strobe is capable of disorienting a person for several seconds, and even after that, the flashing light makes it difficult to coordinate and move quickly; all this can give security officers additional time to react to the situation. In addition, flashes are clearly visible not only with a direct look, but also with peripheral vision, and in the form of reflections.

— Sound (siren). A loud beep that is almost guaranteed to attract the attention of people nearby. In some models, the volume of the siren reaches 110 dB — this is comparable to the engine of an old tractor and only slightly below the pain threshold of a person.

Each of these options has its own advantages, and it is not difficult to combine them in one device. Therefore, most modern cameras with active protection use both methods described above at once.

Operating range of the backlight (see "Design and capabilities") installed in the surveillance camera. This term usually means the maximum distance from the camera to the observed object, at which it is able to provide a relatively high-quality and legible image in the complete absence of other light sources. Of course, the actual backlight range may differ from the claimed one, and these differences are most often in the direction of increase (for example, due to the presence of the same additional light sources). However, if the possibility of shooting with backlight is important for you, you should focus on the claimed range.

Smart home systems that the camera is compatible with.

The general principle of all such systems is to combine various home electronics and household electrical appliances into a single complex so that all these devices can interact with each other and jointly respond to various events. As for surveillance cameras specifically, their functions in a “smart home” are mainly related to reacting to movement in the frame and broadcasting video. For example, a compatible camera can send a notification to the user’s smartphone when a motion sensor is triggered, or transmit video to a TV integrated into the home network.

Nowadays you can find different smart home platforms, the most popular are Apple HomeKit, Google Home, Amazon Alexa. However, there are other options for branded systems - as a rule, they are sold by manufacturers for their smart home and video surveillance devices. To fully work in a particular system, it is worth using cameras that have expressly stated appropriate compatibility. Also, when purchasing a compatible model, it would not hurt to clarify its specific functionality related to the “smart home”.

The size of the matrix installed in the surveillance camera (diagonally).

In general, larger sensors (with the same resolution and sensor type) are considered more advanced: they get more light, which has a positive effect on image quality (especially in low light). On the other hand, increasing the size affects the cost of the entire device; and in some cases (for example, if the camera is not planned to be used in twilight and darkness), a relatively small sensor may be quite suitable.

As for specific dimensions, the most modest cameras in terms of this indicator have matrices of 1/4 "or less. Models with sensors of 1/3.8" - 1/3" and 1/2.9" - 1/2" are very popular, these values can be called average. And in advanced devices, diagonals and more than 1/2 "(up to 1/1.7") are found.

The maximum frame rate in the video captured by the camera.

The higher the frame rate, the clearer the image, the less noticeable blurring when moving in the frame (especially fast). On the other hand, this indicator affects the amount of information recorded during shooting, as well as the cost of the camera itself. Therefore, it makes sense to specifically look for a video surveillance camera with high-speed shooting(45 fps and higher) only if a clear recording of fast moving objects is important to you.

Aperture of the lens installed in the camera.

Aperture characterizes the degree of attenuation of the light flux when passing from the front lens of the lens to the matrix. It is denoted as the ratio of the diameter of the active aperture of the lens to the focal length, while the size of the active aperture is designated as f and is taken as a unit — for example, f / 1.4 or f / 2.0. Moreover, the smaller the number in the designation, the higher the aperture (in our example, the second lens will be darker than the first). And for lenses with a variable focal length (see "Focal"), the actual aperture, usually, changes with a change in focal length; for such models, either the range of aperture values, or its maximum value, can be indicated.

By itself, this parameter characterizes, first of all, how light the image taken through the lens turns out, all other things being equal. High values are important, first of all, when shooting in low light conditions: a fast lens allows you to get a fairly high-quality image without increasing the sensitivity of the matrix, which is fraught with noise and “blurring” of the picture. On the other hand, the actual quality of camera operation (including in dark conditions) also depends on many other factors — the type and size of the matrix, signal processing features, etc. Therefore, aperture in most cases is more of a reference than a practically significant parameter.

Type of camera lens by focal length. Here are the options:

— Permanent. Fixed focal length lenses have a fixed angle of view — in other words, they work at a constant zoom level and are not able to change it (the only option available for such cameras is electronic zoom). The advantages of CCTV cameras with a fixed focal length are simplicity, reliability, almost zero power consumption, small size and low cost. The main disadvantage is the inability to work with optical zoom (see below); and said electronic magnification is less advanced, since when approaching, the clarity of the “picture” decreases.

— Variable (varifocal cameras). Zoom lenses are more complex than "fixed" lenses, are larger, are considered somewhat less reliable, and are noticeably more expensive. However, this type of optics has an important advantage: it is the only one capable of providing optical zoom (see below), which allows you to “zoom in” the image without compromising its quality.

Focal length of the camera lens.

The focal length is such a distance from the lens to the matrix, at which a clear image is obtained on the matrix (when the lens is focused to infinity). The viewing angles of the lens primarily depend on this indicator (see below): the smaller it is, the wider the viewing angles and the smaller the objects in the frame (and vice versa). At the same time, it should be noted that the actual viewing angle is determined not only by the focal length, but also by the size of the matrix (see above). In fact, this means that with different sizes of matrices, lenses with the same focal length will have different working angles. Therefore, only cameras with the same matrix size can be compared with each other according to this indicator. Among CCTV cameras, lenses with a focal length of 2.8 mm, 3.6 mm, 4 mm and 6 mm are considered popular.

In models with a variable focal length (see above), in this case, the range from the minimum to the maximum distance is indicated. Also, using these data, you can derive the optical magnification factor of such a lens: for this, the maximum value must be divided by the maximum (for more details, see below).